How to recover U disk data with EasyRecovery-Methods to recover U disk data

Friends, do you know how EasyRecovery recovers U disk data? So today I will explain the method of EasyRecovery to recover U disk data. If you are interested, come and take a look with me. I hope it can help you.

​ 1. Run EasyRecovery

                    First, we insert the USB flash drive from which we want to recover data to the computer, open the data recovery software EasyRecovery, and select "Data Recovery" on the operation interface.

​​ 2.Select recovery content

EasyRecovery’s recovery content selection interface provides recovery content selection for all data, documents, folders, emails, and multimedia files. We just need to select the type of data we want to recover in our USB flash drive. What I want to recover here is the ID photo stored in the USB flash drive, so I selected "Photos" and then clicked "Next" in the lower right corner.

​​ 3.Select the USB flash drive that needs to be scanned

​ ​ Next we will see EasyRecovery prompting us where we want to recover from. We will see that the connected hard disk below has its own USB flash drive. Check the USB flash drive ("Li Dazui E") and click the "Scan" button.

4. Start scanning

EasyRecovery starts the scanning process, and the duration depends on the content of the USB flash drive. My USB flash drive doesn’t store much, so it only takes 3 seconds to complete the scan.

5.Scan completed

After the scan is completed, you only need to check the files to be recovered among the scanned files, then click "Recover", execute the file recovery command, and then save the recovered data to complete the data recovery operation.

​​ 6. Save recovered data

​​Choose other computer disks other than USB flash drives to store the recovered data.

Common causes of USB disk data loss

​​ 1. Pull out the USB flash drive while reading and writing.

​ ​ 2. Deleted by mistake. There is no recycle bin for deletion here.

​​ 3. Bad sectors appear on the disk, and files happen to exist in this area.

​ 4. The power supply voltage of the U disk interface is insufficient, resulting in a write error, that is, the error message is written to this area.

5. The chip performance is poor and the memory effect fails.

​​ 6. The U disk is formatted by mistake.

​​ 7. The computer suddenly shuts down when the USB flash drive is plugged in.

​ 8. The virus enters the U disk and destroys the U disk data.

How to avoid U disk data loss

​​ 1. Ensure the quality of the USB flash drive and do not buy three-no products on the market.

​ ​ 2. Use the USB flash drive correctly. After using the USB flash drive, please exit it and then pull it out.

​​ 3. Pay attention to placing the U disk in a dry environment, and try to avoid leaving it in a humid environment and getting wet.

​​ 4. Regularly disinfect the USB flash drive to ensure the safety of the USB flash drive.

5. If the USB flash drive is not suitable, do not leave the USB flash drive plugged into the USB interface for a long time, as it may easily cause the interface to age.

The above is the entire content of how to recover U disk data with EasyRecovery brought to you by the editor. I hope it can help you.