Will you not use CREO3.0 to create a bracket parts? Friends who can't come to learn with the editor to learn the operation method of creating a bracket parts with the editor. I hope the study of this tutorial can help everyone more more than everyone can help everyone more more Know the software Creo3.0.

First of all, select the stretching command and make the base part of the bracket. The depth value of the stretch is 8.

Then use the selection command to make a cylinder.

Then, continue to choose to stretch, make a reinforcement, and the tensile depth is 24.

Make another enhanced tendon with a contour rib command, the thickness is 8

Cut out the hole in the middle of the cylinder.

Finally, continue to make the cylindrical on the convex with stretching, and it is created.

The above is the operation method of creating a bracket parts shared by Xiaobian. Friends in need can come to see this article.