Many friends said that they are not clear how to use Creo3.0 to create tire models? The following editors will share with you the method of creating tire models with Creo 3.0. Friends in need can take a look. I hope it can help everyone.

First, open Creo 3.0, and the new physical parts name is Luntai. Stretch a cuboid, the size is as follows.

The stretch of the tire to obtain a pattern on the tire and along the long side array along the tie to get the following Figure 1, and the array parameter is set as shown in Figure 2 below.

Get the pattern on the other side through the mirror command.

Draw the sketch as shown in the figure in the short -term rectangular end face.

Click the ring -shaped bend, the parameter setting is as follows.

Select the two end surfaces of the long recipe in the ring -shaped bend in the upper step to get the three -dimensional model of the tire, as shown in the figure below

The above is the method of establishing tire models shared by Xiaobian. Friends who can't learn can learn it.