When using Creo 3.0, Win10 users encounter problems such as the key in the mouse that can not be zoomed in 3D models. What should I do? The following editors will share with you the solution to the Creo3.0 mouse cannot be scaled. Friends in need can. Come and see, hope to help everyone.

1. Open the Creo3.0 software and find that the key in the mouse cannot be zoomed in 3D model;

2. Open the notification panel in the lower right corner of the computer. As shown in the figure below, find all settings, click to enter;

3. Find the equipment function bar, click to enter;

4. Find the mouse and touchpad settings. The setting of the setting of the mouse setting column "Rolling it when I hang above the non -active window"

5. Set the "Rolling it when I hang up above the non -active window of the hovering", that is, turn off this function;

6. Open the Preo or Creo software again, and the key in the rolling mouse can achieve the reduction of the model, and the problem is solved!

The above is the solution that the Creo3.0 mouse shared by Xiaobian cannot be scaled. Friends who do n’t know can learn it.