The annotation mark family created by Revit cannot be marked normally in the project? Today, the editor will give you a detailed introduction to the processing operations of the annotation mark family created by Revit that cannot be marked normally in the project. Come and take a look!

The picture below is a "loop number" tag family created by the editor to mark wire loops, but the content cannot be recognized when loaded into the project;

There were no problems in the creation process. The reason why I couldn't mark it was that I first created the shared parameter "loop number"; then converted it into a project parameter. When creating the mark family, I created a new share. Parameters; results cannot be recognized when loaded into the project

The shared parameters of the family and the project must correspond and the same one must be used; if a new shared parameter file is created, the previous file must click "Browse" to find the path where the shared parameter file is saved, so that the parameter values ​​in the file can be displayed. The software Shared parameters only show recently edited files.

Come and learn how to handle the annotation mark family created by Revit that cannot be marked normally in the project. It will definitely help everyone.