Bridge summary calculation software

This program is mainly used to calculate the lateral distribution coefficient of solid slabs, hollow slabs or T-shaped beams under load, and to perform reinforcement, etc.

1. Eccentric pressure method:

1. This program is used to calculate the lateral distribution coefficient of bridges with reliable lateral connections and width-to-span ratio B/l ≤ 0.5, using the modified eccentric pressure method.
2. The lateral distribution coefficient of vehicle load has been reduced in accordance with the relevant provisions of the "Highway Engineering Technical Standards" (JTJ001-97).
3. In order to prevent errors, please check manually. I am not responsible for any problems caused by this program.

2. Rigid (hinged) beam joining method:

1. This program is mainly used to calculate the lateral distribution coefficient of hollow slabs or T-shaped beams under load.
2. The upper flange width is the plate width for the hollow plate; the flange cantilever length and the flange plate thickness are both 0 for the hollow plate.
3. Just enter the corresponding data according to the determined calculation requirements. The number of lanes does not need to be entered.

3. Comparison board method:

1. Generally, the number of interpolation points does not need to be changed.
2. For the calculation of bending moment of inertia JX, JY and JTX+JTY values, please refer to the relevant contents of the "Bridge Engineering" textbook.
3. Other values ​​can be filled in according to the prompts in the label bar.
4. Generally, there is no need to tick the checkboxes for detailed data.