How to use the memory cannot be written repair tool? The following are the steps of using the memory cannot be written repair tool introduced by the editor. Friends in need can take a look below. I hope it can help everyone!
1. Unzip the software first, and then double-click the "WrittenSetup.exe" software to install it.
2. The installation wizard will pop up, just click "Next".
3. Do you agree to the installation agreement? Click "I Accept" to proceed with the installation, otherwise it will exit.
4. Select the installation "option". If you are lazy, just let it install. If you are diligent, you can remove the "High Speed Browser". This is rogue software.
5. Select the installation disk. This is usually the default. Otherwise, I will delete the software after using it.
6. It will be installed in less than ten seconds.
7. Start the "Memory cannot be written repair tool" on the desktop, open the program window, and double-click the "Repair" button.
8. At this time, a prompt box pops up to set the XXX software as the homepage. Because I removed the browser software during installation, this prompt will pop up here. Ignore this rogue software for now, click "OK", and then change the homepage later. At this time, it was intercepted by my Kingsoft software, and it happened to be intercepted. If I clicked "Cancel", I will probably exit the software immediately. I have not tried this, and friends who are interested can try it.
9. After waiting for a while, the prompt box "Repair Completed" pops up. Press "OK" to complete the repair.
The above is all the content brought to you by the editor. Have you all learned it?
