Recently, many friends have been asking me how to make titanium alloy for Dyson Sphere Project. Now I will share with you how to make titanium alloy for Dyson Sphere Project. I hope it can help everyone.

Titanium alloy requires sulfuric acid, and the four directions below the tank are set to face upward to give priority to refined oil.

The remaining hydrogen will be divided equally in the four directions. Just 60 hydrogen on the left side is used for the original brown sugar, and 60 hydrogen on the right side is combined with other hydrogens to fractionate heavy hydrogen.

After the refined oil enters the upper tank, it is separated by the four directions above the tank.

150% of refined oil on the left is given to organic crystals, and 90% of refined oil on the right is removed to produce sulfuric acid.

The organic crystal side is set to be output first because the belt here is short.

What's special here is that the bridge is used to limit the speed. From iron plate to steel, the speed of the claws is only 45, and the two claws are exactly 90 iron plates.

90 iron plate produces 30 steel, which is just enough for 30 titanium alloy. I put titanium and titanium alloy in the same box. How much titanium is put in will turn into titanium alloy, so the box will not be blocked.

If you are afraid of blockage, you can leave an empty space. Remember to set up the titanium alloy selection to remove the titanium alloy claws.

The editor has shared here the production method of titanium alloy for the Dyson Sphere Project. Friends who are not sure about it can come and take a look.