How to use Stata to implement LM test? How to operate it specifically? Below, the editor will share with you the operation method of Stata to implement LM test. Friends in need can come and take a look. I hope it can help everyone.
First, import or enter the data we need to process in Stata, and put all the data into Stata software.
After importing the data, we need to establish different data analysis models according to the data type. Different models have corresponding data analysis measurements.
After completing the establishment of the corresponding data model, we can perform appropriate data analysis based on the model. Different data analysis also has different inspection commands.
To perform LM model analysis on the data model, we need to determine the LM data analysis command based on the data and the type of model established.
If it is relatively simple and basic data, you can directly use the fixed test command of the corresponding model:
Such as LM test: xtreg y x1 x2 x3,re vce(cluster id)xttest0
After completing the input of the test command, Stata's LM analysis can be performed. After the system data analysis is completed, the analysis results can be obtained.
The above is the operation method of implementing LM test in Stata shared by the editor. Friends who don’t know how to do it should hurry up and learn it.
