Today, the editor will take you to learn how to turn off orthogonal in AutoCAD 2013. I hope it can help friends in need. Here are the detailed and complete steps. Come and learn with the editor!
1. After opening the CAD2013 version software, use the shortcut command F8 to turn on the orthogonal mode.
2. Or you can click the orthogonal icon at the bottom of CAD2013, as shown in the figure:
3. Draw a straight line through L. After specifying the first point, select the second point to land through the following figure to check whether the line segment is horizontal or vertical. The purpose is obviously to adjust the horizontal or vertical use of orthogonality.
4. The central straight line is not horizontal. We can observe the changes by turning on the orthogonal mode.
5. Automatically draw a horizontal straight line maintaining a horizontal 180 degrees. Of course, the horizontal or vertical direction is determined by adjusting the direction of the line segment with the mouse. The final drawing result is as shown in the figure below. With the above capture we get a straight horizontal line.
The above is the entire content of how to turn off orthogonal in AutoCAD 2013 version. I hope it can be helpful to everyone!
