How to use an oscilloscope in Proteus? Recently, many friends have been consulting the editor on this question, so today I will explain to you how to use an oscilloscope in Proteus. Friends who don't know how to do it can come and learn it.
First, open the required oscilloscope drawing
Click on the icon on the left, the first one displayed is the oscilloscope
点击一下会出现图中样子，调整的合适位置再点击一下放置图纸上
Or you can right-click on the blank space in the picture and follow the instructions in the picture.
Connect the end of the oscilloscope to the chip
Click to run
After running starts, click Debug and select the last one
This way you can see the waveform! (If the waveform does not come out, be sure to check if there is any problem with the connection)
The above is the method of using an oscilloscope in Proteus explained by the editor. I hope it can help everyone.
