Maybe there are many friends who still don’t know how to find the exclusion in proteus? So those who are not sure yet should come and take a look at the method of finding the exclusion in proteus brought by the editor. I hope it can help everyone.
1. Open the installed Proteus, click "Library" in the upper menu bar, and then select "Select Parts from Library", or right-click the mouse in the component list on the left, and then click the "Select from Library" option in the right-click menu.
2. The component library will be opened later. We open the "Resistors" in the category, find the two items "RESPACK-7" and "RESPACK-8", select them respectively and click "OK" in the lower right corner to add them to the component list.
3. After that, we right-click the mouse in the blank area of the picture, and the mouse cursor points to "Place" - "Component" in turn, and the two exclusion components previously added will appear.
4. Afterwards, you can add two components in sequence and modify their properties.
The above is the method brought by the editor to find the troubleshooting in proteus. Have you learned it? I believe it will be helpful to everyone.
