- Green versionCheck
- Green versionCheck
- Green versionCheck
- Green versionCheck
How to put the printer into maintenance status:
1. Turn off the power of the printer, and while pressing the "Continue/Cancel" key (some machines call it Stop/Reset), press and hold the "ON/OFF" key of the power supply;
2. When the power indicator light lights up green, press and hold the power "switch (ON/OFF)" button and release the "continue/cancel" button;
3. While holding down the power "switch (ON/OFF)" button, press the "continue/cancel" button 5 times, then release the power "switch (ON/OFF)" button and the "continue/cancel" button.
(Note: Only release the power "ON/OFF" button now. The power "ON/OFF" button was pressed in the first two steps)
[Each time you press the "Continue/Cancel" key, the alarm and power indicator lights will flash alternately, the alarm indicator light will be orange, the power indicator light will be green, and the alarm indicator light will flash first]
4. When the power indicator light lights up green, the printer is ready for maintenance mode operation (if it does not enter maintenance mode, please turn off the printer and restart it according to step 1.2.3)
5. The computer prompts to find new hardware and prompts to install the driver. Leave it alone. If the new hardware is not found, it is recommended to restart the computer or try changing the computer. (If the computer cannot find the new hardware, the reset software cannot be used)
it works
it works
it works