This is an expert modified version, very suitable for novices! And it comes with DiskGenius
How to use:
Install to the D drive by default. Do not change the path at will. Rename the ISO that needs mass production to YYYY.ISO and put it in the root directory of drive D
The configuration files have all been set up, a total of 2 configuration files. One is formatting.
One is to plug in the mass-produced USB disk and format it. After a while, a dialog box [OK] will pop up.
Unplug the U disk and plug it in again. Wait for 20 seconds and click OK to continue. After a while, the box turns green to indicate success. Unplug the USB flash drive and plug it in again
Then click Phison Master v1.96 Fool Edition to select the mass production configuration. Click Start. After a while, the box will turn green.
Mass production was successful. Unplug the USB flash drive. If you are pursuing speed, use diskgenius format. Choose 16K.
If you want to burn ISO disc to USB flash drive again
First you need to reformat the USB flash drive
==========================
1. Execute F1_90_v196_00.exe
Click for information
Select Format.ini from the drop-down menu
Just click start
A dialog box will pop up in the middle. At this time, unplug the USB flash drive and plug it in again after 1 minute. Click OK to continue.
When all is complete, the first box will turn green.
Close the program, unplug the USB flash drive and plug it in again. The initialization and formatting is completed. It becomes a USB flash drive.
============================
Burn ISO [Note D:YYYY.iso] Do not change the ini or rename the iso you need to YYYY.iso and put it in the root directory of the D drive
1. Execute F1_90_v196_00.exe
Click for information
Select mass production.ini from the drop-down menu
Just click start
When all is complete, the first box will turn green.
Close the program, unplug the USB flash drive and plug it in again. The initialization and formatting is completed. It becomes a USB flash drive.
This will complete a 21-mode combination of CDROM+U disk
================================
The above two INIs have been prepared and there is no need to touch them again.
Note that this directory should be placed in the root directory of drive D.
For other drive letters, the paths in the two ini files can be modified according to specific circumstances.
[Firmware]
ISP=1
Burner File=D:v1.96.00BN206.BIN
Firmware Name=D:v1.96.00FF0110D.BIN
Verified Firmware Name=D:v1.96.00FF0110D.BIN
it works
it works
it works