Lewang Rack Instructions for Use
We can also record the position of the entire panel and set various parameters of the sound card. Next, let’s take a look at how to operate the Lewang rack step by step:
2. Sound card settings
After opening it directly, you first need to set the sound card driver, sampling frequency and other parameters in the sound card settings window. The selection of special input and output devices will affect the settings of each subsequent module. For further settings, you can open the sound card panel for further settings. If installed Users who have a dedicated sound card will see various information about the sound card in the above section. After the settings are completed, they can turn on the main switch to turn on the sound card and start the rack. In addition, you can select the size of the current panel display through the panel size button. (Note: Before turning on the main switch, please make sure that there will be no howling between the microphone and the speaker. Especially for laptop users, you can turn on the main switch after all configurations are completed)
3. Anchor sound module
In the anchor sound module, we select the sound source in the middle input selection to configure the anchor's voice. In the "Voice Effect" column at the top, there are six modes to choose from. You can also use the letters of the keyboard " A" to "H" are used as shortcut keys to quickly switch sound modes. The switch in the lower half can turn off the input of this part with one click. The fader can control the volume of this part's output to the main output. The two knobs on the lower left can Controls the volume sent to the auxiliary outputs "On Air" and "Lian Mic".
4. Lianmai module
In the Lianmai module, after selecting the input channel, you can receive the Lianmai sound signal transmitted from the network. You can also control the corresponding output volume through switches, faders and knobs.
5. Music playback input module
If you want to play music through other external music player software and input it into this rack, you need to select the corresponding input interface in the input selection in the middle, and control various sends through the buttons and faders below volume. In particular, if you want the music volume to automatically and dynamically decrease based on the host's volume during broadcast, you can light up the "Dodge" button.
6.Sound effect module
In the sound effect module, you can click on the top to trigger the corresponding sound effect. At the same time, in the middle of "Custom 1" and "Custom 2" and the matching "Settings" button, click "Settings" to import a sound effect and pass " Customize" key to trigger (note: the imported sound effect file needs to be one of the following mp3, wav, aiff).
Likewise, we can control the amount of sound sent in this part through the selections and faders below.
7. Auxiliary output module
In the auxiliary output module, we first need to select the "Broadcast Output" track and "Lianmai Output" at the top"The channel of the sound card corresponding to the track, and then its volume can be controlled through the switches and faders below.
8. Main output module
The main output module is also the monitoring output module. In this section, we can first select the sound source we want to monitor at the top, and then configure the corresponding output track, and then control the volume through the switches and faders below.
9.Panel snapshot module
In the panel snapshot module, you can record 5 sets of the current positions of all faders and knob switches on this rack through the storage and read keys below.
10. Others:
You can learn other information and usage instructions of this software by clicking "About" and "Help" in the upper right corner of the panel.
Other instructions
1. Different sound card configuration methods may be slightly different, please refer to the sound card manufacturer's instructions.
2. When using a non-Asio driven sound card, there will be a slight lag when switching effects and controlling volume.
3. Note: There is no write permission under the C drive Program of Win10 and parameters cannot be saved. Please install the rack program on the "D" drive.
4. If MSVCP120.dll is lost, please go to the official website of Lewang Rack: https://www.mkrack.com/index.php/mk-rack.html to install the VS 2013 support package.
it works
it works
it works