- Green versionCheck
- Green versionCheck
- Green versionCheck
- Green versionCheck
Basic introduction
Supported models: TOP853/2005+/2007/2009/2049/3000/3100/3200.
When connecting to the programmer for the first time, to register the device driver with Windows, please follow the steps below:
Connect the computer USB port and the programmer with a USB cable. The red light on the programmer is on, but the green light is off.
Found new hardware, basically normal.
If the USBDevice is not recognized, subsequent installations will most likely fail.
It may take 10 to 60 seconds to start searching for the driver...
If it times out, you can only click Cancel and reinstall. OK, found, press [Finish] to end.
"TopWin" can now be run, and the green light of the programmer is on. The chip can be read and written.
Some microcontrollers, such as PIC12f629, sst89c58, at90s8515...etc., need to write data in addition to programs. The program is written from address 0000, and the data is written from the address specified by the chip. (Indicated by the lower right of the buffer window ("Datafromxxxx toxxxx")).
This function is to accurately write the data file to the address specified by the chip. The loading steps are the same as "Open File". Note that the chip with a write data segment must be selected before loading.
it works
it works
it works