Function introduction
1. Redesign the pipeline system settings so that users can add pipeline systems and pipeline partitions by themselves.
2. The functions related to the pipeline system have been updated. The original functions corresponding to the specified system can support the operation of newly created partitioned pipelines under the system.
3. A new siphon rainwater system is added to the pipeline settings, which is used to draw separate siphon rainwater pipes and supports the related functions of the siphon rainwater module.
4. The electric valve library is added to the library. Electric valves can be selected when the valve parts are ordered to be arranged. The arranged layers correspond to the electric valve layers added in each pipeline partition.
5. Add separate sprinkler head layers to each zone of the sprinkler system.
6. Water supply system related functions support gray water system pipelines.
7. Calculate the corresponding pipe fitting equivalent according to the selected pipe material; perform hydraulic calculation according to the pipe inner diameter of the corresponding pipe material; users can input the total height difference loss and safety factor to determine the design lift.
8. Added water hammer pressure calculation function, which is used to calculate the pump-stop water hammer pressure of the fire water pump outlet pipe.
9. Add the corner inspection function, which is used to inspect pipes with water flow angles less than 90° in outdoor pipe networks.
10. Improve the problem that some functions cannot operate on external references to support the identification of external reference objects; optimize the functions that require extra steps to operate on external reference objects and reduce the operating steps.
How to use
1. Open the software first!
2. Unzip the time patch and double-click to open and run!
3. Click to use!
Things to note
The patch is applicable to Tianzheng Water Supply and Drainage v3.0 and v4.0 versions, and can be used by both!
it works
it works
it works