- Green versionCheck
- Green versionCheck
- Green versionCheck
- Green versionCheck
Software features
1. The whole process is one-click installation, which does not require any technical foundation, and even a novice can get started immediately;
2. Full-featured, not only able to reinstall the system, but also capable of virus scanning, data recovery, etc.;
3. It does not occupy the tool carrier, such as using a USB flash drive to make a boot disk, which is usually used to store files and only transforms into a boot disk to repair the system at critical moments;
4. The system can be replaced freely at any time and at any time, and the operation is simple to facilitate the needs of the majority of users;
5. The official version of the Shenshan Hongye PE Toolbox uses write protection technology to cut off the spread of viruses and prevent viruses to the greatest extent.
Installation method
1. Prepare a U disk larger than 2G and back up relevant data to prevent file loss due to the U disk being cleared;
2. Download the Shenshan Hongye PE toolbox installation program software and select the desktop as the storage location, which will facilitate the subsequent program installation;
3. Download the required system files and select the desktop as the storage location to facilitate subsequent copying of system files;
4. Find the downloaded Shenshan Hongye PE toolbox installation program on the desktop and double-click to run it;
5. After opening the main interface of the software, select the installation location. You can choose whatever you want at this time. There are no special requirements. After selecting, click to start the installation;
6. Enter the software installation process, and you can know how far the software has been installed from the progress bar on the interface;
7. After waiting, the progress bar is full, and the installation of the Deep Mountain Red Leaf PE toolbox is completed. Click to start making and running the main program interface;
8. After opening the main program interface of the Shenshan Hongye PE toolbox, as shown in the figure below, you will be prompted to insert the U disk;
9. After selecting the default installation location, insert the U disk and wait for the program to automatically identify the details of the U disk. After the recognition is completed, click to start production;
10. A warning window will appear next. This operation will delete all data and cannot be restored, so click OK after backing up the U disk data;
11. After clicking OK, enter the process of making the boot USB flash drive. You can know the production level from the progress bar on the interface. The whole process takes about 1-2 minutes, which is mainly related to the reading and writing speed of the USB flash drive;
12. When the progress bar is full, a prompt that the creation of the bootable USB disk is completed will appear. It is recommended to test the next simulation test. At this point, the creation of the bootable USB disk is completed;
13. Copy the downloaded system files to the "GHO" folder of the USB flash drive. After the copying is completed, a complete bootable USB flash drive will be created successfully.
it works
it works
it works