What should I do if the wifi sharing wizard fails to open and a 1502 error occurs? The wifi sharing wizard is a network tool that can provide users with free wifi hotspots. It is a good helper for surfing the Internet in our lives. With it, you don’t have to worry about being unable to access the Internet. But sometimes the wifi wizard will fail to open, such as error codes 5023, 1002, and 1502, making it unusable. So what is the reason for the error code 1502? The following editor will introduce to you the reasons and solutions for the 1502 error when the wifi sharing wizard fails to be opened. Please see below for details!

Introduction to the reasons why the wifi sharing wizard failed to open and a 1502 error occurred:

It cannot be turned on because the IP of the virtual network card assigned by the system is incorrect.

Solution:

1. Open the Network and Sharing Center, as shown in Figure 1:

(Figure 1)

2. Click Change Network Adapter Settings, as shown in Figure 2:

(Figure 2)

3. Open the CMD command as an administrator, as shown in Figure 3:

(Figure 3)

4. Run the netsh wlan set host mode=allow command and press Enter, as shown in Figure 4:

(Figure 4)

5. Find "Microsoft Virtual WiFi Miniport Adapter" or "Virtual Network Adapter" in Change Adapter Settings

Right-click and click Properties, find IPV4 and double-click to manually change the IP address and subnet mask, as shown in Figure 5:

(Figure 5)

6. Start the WiFi sharing wizard, as shown in Figure 6:

(Figure 6)

The above is the reason and solution for 1502 when the wifi sharing wizard fails to be opened for users. I hope it will be helpful to everyone!

The editor recommends:

How can the wifi sharing wizard blacklist others?

The solution to the problem that the wifi sharing wizard cannot detect the wireless network card

What should I do if my mobile phone cannot find a hotspot with WiFi Sharing Wizard?