Many people don’t know what are the cornering methods in Forza Horizon 5? Today’s article brings you an introduction to the cornering methods in Forza Horizon 5. If you still don’t know, let’s learn it with the editor. .
1. Go to the corner: brake, cut into the corner, accelerate.
2. Handbrake drift: Slow down, downshift, press the handbrake, and after the car starts to slide, slowly apply the gas to accelerate.
3. Inertial drift: slow down, downshift, release the accelerator when cutting corners, and then apply the accelerator hard.
4.sideBreak drift: no need to brake, downshift more than two gears when cutting corners.
5. Fake drift: Before entering a corner, turn in the opposite direction, and then quickly turn back to the cornering direction.
6. Break the drift: Depress the clutch when entering the corner, slow down, downshift, but do not loosen the gas, and release the clutch immediately when reaching the center of the bend.
7. Swing drift: before entering the bend, depress the clutch, tighten the handbrake, adjust the direction, release the clutch and handbrake after reaching the center of the bend, and accelerate.
Forza Horizon 5 System Requirements
Minimum configuration:
Requires 64-bit processor and operating system
Operating system: Windows 10 version 15063.0 or higher
Processor: Intel i5-4460 or AMD Ryzen 3 1200
Memory: 8 GB RAM
Graphics card: NVidia GTX 970 OR AMD RX 470
DirectX version: 12
Network: Broadband Internet connection
Storage space: 110 GB available space required
The above is the complete content of Forza Horizon 5 cornering methods shared with you. Friends who are interested, please come and watch!
