In the process of using UG11.0, how do you type around an arc? In fact, the operation is very simple. Now I will share with you the operation method of UG11.0 around an arc. Friends who need it can come and take a look. , hope it can help everyone.
First, open UG11.0, select (Home)-Select (Sketch), the (Create Sketch) dialog box will pop up-Select (OK)
Secondly, select (Arc), the (Arc) dialog box will pop up-select (center and endpoints define arc)-select any point as the center of the arc-select the starting point and end point of the arc-select (complete sketch)
Next, select (curve)-select (text), a text dialog box will pop up-select type (on curve)-select (select curve)-select the arc line just drawn-enter the characters to be entered under the text attribute- Adjust the aiming point position in the text box. You can make no adjustments by default - adjust (offset/length/height) under the size. After achieving the result you want, select (OK)
Finally, it’s done.
The above is the operation method of UG11.0 arc typesetting shared by the editor. Friends who don’t know how to do it, please come and learn it.
