How to use an oscilloscope in Proteus? Recently, many friends have been consulting the editor on this question, so today I will explain to you how to use an oscilloscope in Proteus. Friends who don't know how to do it can come and learn it.
First, open the required oscilloscope drawing
Click on the icon on the left, the first one displayed is the oscilloscope
Click to appear in the picture, the appropriate position of the adjustment, click on the placement drawing on the drawing drawing
Or you can right-click on the blank space in the picture and follow the instructions in the picture.
Connect the end of the oscilloscope to the chip
Click to run
After running starts, click Debug and select the last one
This way you can see the waveform! (If the waveform does not come out, be sure to check if there is any problem with the connection)
The above is the method of using an oscilloscope in Proteus explained by the editor. I hope it can help everyone.
