How to configure the device using 3CDaemon-TFTP software 3CDaemon usage tutorial

Don’t you know how to use the TFTP software 3CDaemon to configure the device? If you don’t know how, you can take a look at the method of using the TFTP software 3CDaemon to configure the device. I hope that this tutorial can help everyone.

1. Device configuration that requires log:

Additional configurations required for equipment (routers, switches):

#info-center loghost 11.60.133.7 // IP is the IP address of the host where 3CDaemon software is installed #

2. 3CDaemon software configuration:

(1) As shown in the figure, create a new folder

(2) Select "Only the IP address specified for me" in the drop-down menu

3. Set the IP address and save it after the setting is completed.

The above is the method brought by the editor to use the TFTP software 3CDaemon to configure the device. Friends in need should not miss it.