Some friends will encounter the situation that the Canon MP288 clearing software is not responding. What should they do? The following editor will share with you the solutions to the Canon MP288 clearing software not responding. I hope it can help everyone.
1. Enter maintenance mode:
01. Make sure the printer power switch is turned off, first press the [Cancel/Stop] key, and then press the [Power Switch] key. (Do not release either button.)
02. When the power light lights green, do not release the [Power Switch] button at the same time. Release the [Cancel/Stop] button, then press the [Cancel/Stop] button 5 times, and then release the [Power Switch] at the same time. [Cancel/Stop] key. (Each time you press the [Cancel/Stop] button, the alarm light and power light flash alternately.)
03. When the power indicator light turns green, the printer is ready for maintenance mode operation.
2. Use Canon MP288 clearing software:
01. Open the Canon MP288 reset software and click Clear.
02. Print out a piece of paper with the words D=000.0, indicating that it has been cleared.
The above is the solution shared by the editor for Canon MP288 reset software not responding. Friends in need can take a look.
