I believe many users know that iQiyi Universal Player supports DLNA screencasting. Videos on the computer can easily be cast to other settings for playback. Today I will share the operation process of iQiyi Universal Player for screencasting. , friends in need come and take a look!
First of all, make sure that the device you want to mirror and playback supports DLNA and is in the same network segment as the computer network. To put it bluntly, it means connected to the same router. After meeting these two requirements, you can play it.
Open the player, put a video you want to cast to the player and start playing it. Right-click on the playback interface and click [DLNA Cast], or directly click the third button in the lower left corner.
Then look for the name of the device you want to cast the screen to in the pop-up window, click [Connect], wait a few seconds, and wait until the status connection is checked. If the currently connected device is displayed, it means the connection is successful, and then look at the screen casting Is the device playing normally? There is no picture when playing locally, only the name of the video and the name of the connected device are displayed.
If you want to disconnect from screencasting, click [Disconnect].
Note, if you cannot connect the DLNA device, then confirm the following points
1. The DLNA device is turned on
2. The network connection is normal
3. The DLNA device and the machine are on the same network.
After confirming that the above points are met, click Refresh to refresh the device again. Also note that the network connection for DLNA playback must be good, otherwise lags may occur. It is recommended to use a wired connection instead of a wireless connection.
Friends who still don’t understand the operation process of iQiyi Universal Player for screencasting, don’t miss this article brought by the editor.
