Mobile Uncle’s special mtk flash tool

Mobile Uncle's dedicated mtk flash tool is the latest dedicated flash tool software released by Mobile Uncle's ROM group. With this tool, you can easily flash your phone with one click. You can wire flash mtk6589 quad-core mobile phones, and you can also bring bricked Redmi phones back to life. , Mobile Uncle’s special mtk flash tool basically supports mtk6592, mtk6589, mtk6595 and other platforms.

How to use Mobile Uncle’s special mtk flash tool

Let’s take the Redmi phone as an example. The following is a tutorial on how to quickly brick a Redmi phone.

Step 1: Download the following wired flash ROM, flash software and flash driver to your computer:

1.MTK smart phone usb driver - a complete list of essential drivers for flashing

2.MTK mobile phone flash driver (including 64-bit)

3. Special flash tool for Redmi phones

Under ROM: Redmi mobile phone flash original factory partition rescue package decompression password: bbs.ydss.cn

If the ROM is too large, you can only use a third-party network disk.

The second step is to install the necessary flash driver

Open the folder decompressed from the first step and find "MTK Smartphone USB Driver - Essential Driver for Flashing.rar". After decompressing, enter the "Automatic Installation Version of Flashing Driver" folder and click "Click to install by Uncle Mobile.exe" "Perform driver installation. If the computer is 64-bit, please click "installdrv64.exe".

PS: Windows 8 system has not been tested!

My system is Windows Vista Home Basic

Steps to identify the flash driver: After installing the driver, unplug the battery from the phone, connect it directly to the computer without a battery, and the hardware will pop up and be discovered.

(PS: If unsuccessful, please change the USB port and change the computer system to XP)

If an error occurs during the driver installation process and a message such as "The paragraph in the inf is invalid" is displayed, please download the missing file and put it in the relevant folder in the Windows directory.

Copy mdmcpq.inf to c:/windowsinf

Copy usbser.sys to c:/windows/system32/drivers

The third step, the specific graphic flashing tutorial is as follows:

First open the flashing software, click Load scatter and select the text in the line flash ROM.

(The picture comes from the Redmi large memory version post, the steps are the same, some file names are different, it does not affect flashing)

ok, the above are all the preparation steps before flashing the machine

When flashing the phone, you need to remove the battery and install the brush. Here is a brief explanation of the process:
Connect one end of the data cable to the computer, turn off the phone, pull out the battery, click on the flash software (firmware → upgrade), connect the other end of the data cable to the phone, then install the battery, and the flash will start. (The progress bar of some computers is already moving before the battery is installed on the mobile phone, so don’t worry about it. Just wait until the flash is finished... The success rate is higher when the battery is installed)

When the driver is installed, the progress bar below will start to scroll. . It will take about 5 minutes until the word OK appears to indicate flashing.

PS: When the power supply is insufficient, you need to install a battery brush! Just put the battery back on the phone before clicking firmware upgrade. The operation is similar.

The sign of successful flashing is as shown below

After the flash is successful, unplug the data cable and install the battery (please ignore those who installed the battery to flash the phone ==)

Then you can turn on the computer. This brush package is the original one. It does not come with ROOT. If you need ROOT, please use ROOT Master!

Picture appreciation:

There is no need to appreciate this. .

The original system, I believe everyone has experienced it

The still and software has not been deleted and the still and software has not been added.

Let’s get one~ha~