Create U disk system disk (WinToFlash)

Making U Disk System Disk (WinToFlash) is a tool used to make system disk. With WinToFlash, everything becomes very simple. It is a software for making USB system disks. It supports Windows XP, 2003, Windows Vista, Windows 2008 and Windows 7 systems, allowing you to easily install the operating system without a CD-ROM drive.

Brief description:

Nowadays, netbooks are very popular. Unfortunately, they do not have optical drives. You can only install the operating system by connecting an external optical drive, which is very inconvenient. In fact, we can install the system through a USB flash drive, but making a USB installation disk is more troublesome. .

wintoflash tutorial, how to use WinToFlash:

Unzip and run

The following picture pops up

Click accept

Click on the task. . . .

In the drop-down menu, you can choose the system to install to the USB disk or memory card.

Select the picture below

Then click Run in the lower right corner.   

The following picture pops up

Then load xp.iso to the virtual optical drive

Open the iso file and then as shown in the figure

Click to load

Watch it on my computer,

This is the drive letter on my computer. On your computer, that one is the drive letter of the virtual optical drive, whichever one it is.

Then return to the previous interface

Windows source path, click Select, and the window on the right will pop up. Select the disk where the i386 folder is located.

(Because the image is loaded into the virtual optical drive, it goes to the disk of the virtual optical drive)

Then click OK.

Then plug in the USB drive, select your USB drive, and then confirm.

Then click Run. Pop up as follows

Select I accept

Then click Continue. . . . . . .

A warning pops up to format the USB flash drive. If there is data on the USB flash drive, remember to back it up to the local hard drive.

There is nothing in my USB disk here, just confirm it. . . . . . . .

Then just wait for it to complete. . . . . . . . . . .

Then click OK.

Close the software. test

It prompts that there is an update, click No, just close it.

Then run bootice.exe

Click on the master boot record,

Then select ultraiso USB-HDD+

Click install/configure

Then click OK.

Close bootice.exe.

Easy launch tester.exe

This is the download address of the test software

My USB flash drive is 4G.

Click start

Choose the first one. . . . .

Then comes the installation process. Just follow the prompts. If you don’t understand the specific steps, there are also instructions for installing the installation version of the system online.

Finally, uninstall the image loaded to the virtual optical drive.

Just click Uninstall.