How to use furmark?
First, open the FurMark software and click the red button to set it to off to turn off the anti-aliasing function.
Click on this setting and set it as shown in Figure 2.
Click ok and click this test.
Click this go, and the software starts to bake the machine.
The information displayed in the upper left corner of the software includes information about the frame rate at this 800x600 resolution, temperature, and CPU energy consumption. You can see here how the performance of this GPU is. To hide the above information, press the letter [i]. To restore the display, press [i] again.
If you want to match its rendering mode, press the space bar to switch. The results obtained in different rendering modes are different. Then if the computer can run this software for an hour without crashing, then it means it is good. Usually a fifteen-minute run is enough, preferably forty minutes or within an hour. Seeing this tem temperature, anything below 80° is qualified. The lower the temperature, the better. High-end graphics cards are usually above 90°, and ordinary games are generally 60°. For daily computer use, just run it for an hour and see if there is any problem. If there is no problem, then this computer can be used. The reverse is not possible.
How long does it take to bake furmark without damaging the graphics card?
It is recommended not to exceed 30 minutes.
Generally, the copy test lasts for 15 minutes. For more strict tests, half an hour is enough.
FurMark is a baking software that is used to detect computer graphics cards. However, the graphics card will always be in a high temperature state during use, which is still harmful to the graphics card.
