How to draw arrows in AutoCAD 2007? In fact, it is very simple. The following content is the method of drawing arrows in AutoCAD 2007 compiled by the editor. Friends in need can learn together!
First, open the AutoCAD 2007 software, as shown below, and set it to orthogonal.
Then, enter "PL" in the command bar.
type in the “w” command and hit the Enter key.
After that, enter the number "30" in the command bar below.
Then, slide the mouse to the next specified point.
being entered in "100" in the command bar, as shown below, and click the Enter key.
Finally, the arrow drawn is as follows.
The above article explains how to draw arrows in AutoCAD 2007. I hope friends in need can learn it.
