There are many friends who use AutoCAD2010 but do not know how to set graphics boundaries. For this reason, the editor here describes the operation method of setting graphics boundaries in AutoCAD2010. Friends in need can learn with the editor.
Double-click the shortcut coordinates of AutoCAD2010, as shown below. The graphics in this picture were drawn randomly by the editor.
-- be entered the command "limits", which is entered here, and it is not case-sensitive. This command means to reset the model space boundaries. As shown in the picture, press the Enter key again.
force with which ---- as a If you want to set the A4 paper size, continue to enter 0,0;210,297. As shown in the picture. Of course, the paper size of A3 is 297mm×420mm, so you have to enter 0,0;297,420 in the command box.
Of course, it can also be set according to personal needs. For example, after entering the command limits, enter the graphic limits you want to set. Here we will introduce a situation, as shown in the figure. You want the red rectangle in the figure below to be the boundary of the graphic. What should you do?
At this time, you need to capture the coordinates of the lower left corner and upper right corner of the rectangle. Directly select the rectangle, as shown in the picture. First select the right angle in the lower left corner, and then look at the coordinates of the command box in the lower left corner. In the same way, capture the coordinates of the upper right corner endpoint, follow the above operation, first enter limits, then enter the two points respectively, and press the Enter key, so that the graphics limits are set.
The above explains how to set graphics boundaries in AutoCAD 2010. I hope friends in need can learn it.
