Still don’t know how to use extension commands? Friends who have just started the autocad2008 software recently said that they are still unclear. For this reason, the author here will share with you the operation content of using extended commands in autocad2008. I hope it can help friends in need.
Open the drawing paper of autocad2008,
If you want to extend the straight line shown in the picture below to intersect with the left side of the circle, you can click the "Extend" tool;
The prompt bar at the bottom of the screen will display: Select the object. This object is the object to be extended, which is the object that will eventually be extended to. Click the circle with the mouse, as shown in the picture, and click OK (it can be a space or the "enter" key) ;
Click on the straight line to extend, but it will extend to the left side of the circle, because the software will default to the first intersection point at this time.
Click again on the straight line you want to extend, and it will extend to the left intersection point of the circle.
The extend command is suitable for extending a straight line to a fixed target, and eventually the two targets intersect. You can also extend the diagonal line as shown in the figure to the bottom straight line, as shown in the figure. The operation steps are the same as above;
Come and learn how to use extended commands in autocad2008. It will definitely help everyone.
