How to make a U disk version of PE boot disk in Ghost32? Below I will share with you the tutorial on how to make a U disk version of PE boot disk in Ghost32. If you need it, you can learn more.
Double-click: Ghost32.exe on the computer desktop to install the USB WINPE USB boot disk, select "Local" → "Disk" → "From Image".
In the pop-up interface, click the small black triangle button with the mouse, and then find your gho image file from the drop-down list to display some information about the image file. Click the gho image file. If the mouse cannot be moved, you can use the "TAB" key. Operation, select the "0pen" button to continue, and the "Cancel" button to: suspend or cancel.
Select the USB flash drive to be installed. You can tell by looking at the capacity. Be especially careful in this step. Don't make the wrong choice, otherwise useful data will be overwritten.
Choose "OK"
A dialog box will pop up, confirm that everything is correct and select “Yes”.
Wait for the blue progress bar to reach 100% (the mouse pointer is hidden during this process, the length of time is determined by factors such as machine configuration and data size, generally ranging from 2 to 20 minutes). The six dynamic values in the blue area in the middle of the figure below are from top to bottom: completion progress percentage, speed MB/min, amount of copied data, amount of remaining data, elapsed time, and remaining time.
A successful completion dialog box will pop up. Click "Reset Computer" to restart the computer. Click "Continue" to continue and return to the initial interface of Ghost.
The above is all the content brought to you by the editor. Have you all learned it?
