Many friends say that they still don’t know how to generate cones in UG11.0? So friends who are not sure yet can come and learn with the editor how to generate cones in UG11.0. I hope that through the study of this tutorial, you can Help everyone better understand the UG11.0 software.
Open UG11.0, first generate a part model, click New, then select the model, and then confirm.
After entering the model, find the cone in the shortcut keys on the menu bar and click this command.
After that, a set of values will appear on the left side, here are the diameter of the upper and lower bases of the cone and the height of the cone.
After setting the three values of the cone, click OK.
After that, you can see in the model diagram that a cone has been generated.
What needs to be explained here is that if your upper bottom height is set to 0.
What you can see is a cone without an upper surface.
The above is the method of generating cones in UG11.0 shared by the editor. Friends in need can take a look.
