Some friends said that they encountered a situation where they could not open pictures through the photo viewer, and they were prompted with the message "The module shimgvw.dll has been loaded, but the entry point DllRegisterServer cannot be found." What should I do? Today I have brought you shimgvw The .dll is loaded, but the entry point cannot be found.
【Solution 1】
Open Windows Explorer, click to enter: Organization > Folder and Search Options > View, and uncheck "Always show icons, never thumbnails"
【Solution 2】
1. Open "System Properties" in the "Control Panel", click the "Advanced" option, and in the pop-up dialog box with visual effects, select "Adjust for best appearance" or select "Customize" and click " "Show thumbnails instead of icons", just make it selected and confirm to see the effect.
2. Enter "regsvr32 shimgvw.dll" (enable image preview) in "Start → Run"; then run "regsvr32 shmedia.dll" (enable image preview). After registering the DLL, a window should pop up prompting "... in... ...success" and click OK. If you want to cancel the preview, such as canceling the video preview, run "regsvr32 /u shmedia.dll".
【Solution 3】
1. Use the mouse to select "Start → Run".
2. In the "Open" column of the subsequent pop-up window, type: regsvr32 x:winnt\system\thumbvw.dll and click the "OK" button. The x in this command should be replaced with the disk partition number of the actual installation of the operating system. If you install Windows 2000 on the C drive, the x should be replaced with C.
3. After executing this command, the image preview function can be restored.
The above is the solution brought by the editor that shimgvw.dll has been loaded, but the entry point cannot be found. I hope it can help everyone.
