How to use creo6.0 to create a variable round? Some friends may not know yet, so the editor below will share with you the method of creating a variable round in creo6.0. Friends in need can come and take a look. Oh, I hope this helps everyone.
First, open the graphic to be rounded in creo6.0, and then click the round tool as shown in the figure below.
Select the edges to be rounded;
Enter the rounding value as shown in the figure below. So far this is a conventional rounding operation. So how to achieve rounding with different radii on one side? Continue to look at the key points below.
At the dot position as shown in the picture below, right-click and hold, and then select "Add Radius".
Enter a radius value.
Then follow step 4 to add a radius value, as shown in the figure below. Enter the radius value at 6 and the position of the radius on the curve at 7 (percentage position, 0.8 represents the 80% length position of the line segment starting from the starting position).
Repeat the above steps to continue adding the radius.
The final effect is as shown in the figure below, so that the variable radius round is created.
The above is the method of creating variable round corners in creo6.0 shared by the editor. Friends who don’t know how to do it can learn it.
