How to use CAD Viewer to measure distance? Some friends may not know it yet, so friends who don’t know how can come and learn with me how to measure distance using CAD Viewer. I hope you can pass this tutorial. Learning can help friends better understand the CAD Viewer software.
First, open the drawing in CAD Viewer.
In edit mode, click the "Distance Measurement" command in the extended toolbar.
Select the specific location where the distance is to be measured, that is, specify the first point of the measurement location, and click the left mouse button to confirm the first point.
Select the next point where the distance needs to be measured, that is, select the second point to measure the distance, and determine the distance between the two points, as shown in the figure below:
After selecting the two points to be measured according to the above four steps, the distance between the two points is now at the bottom of the interface. As shown in the figure below, the distance and angle between the two points are displayed, and there is also a total. It means that the distance measurement function can perform continuous measurements. After measuring the distance between these two points, you can continue to measure the next distance from the second point.
Measurement results can be saved, and various measurement results can be exported to Excel tables:
Click "√" at the back of the measurement results dialog box to save the measurement results.
The saved measurement results can be viewed in the measurement record, or the measurement results can be exported to an Excel table.
The above is the distance measurement method of CAD Viewer shared by the editor. I believe it can help everyone.
