How to restore the partition using the MaxDOS toolbox? How to do it specifically? So today I will explain to you the method of partition recovery using the MaxDOS toolbox. Friends in need can come and take a look. I hope it can help you.
1. First, insert the prepared Chinese cabbage USB boot disk into the USB interface. After the USB disk is successfully started, move the cursor on the Chinese cabbage main menu interface and select "[07] Run MaxDos Toolbox Enhanced Edition Menu" and press Enter to confirm. As shown below
2. Come to the MAXDOS toolbox selection interface, move the cursor and click to select "[01] Run MaxDos9.3 Toolbox Enhanced Version C" and press Enter to confirm. As shown below
3. Select "A.MAXDOS Toolbox" in the opened MAXDOS main menu interface and press Enter to confirm. As shown below
4. In the tool selection interface of the MAXDOS toolbox, enter "pr" and press Enter to confirm opening the partition recovery tool. As shown below
5. Next, start the partition recovery operation. In the pop-up interface, move the cursor to select the partition that needs to be restored, and then press Enter to confirm. As shown below
6. In the pop-up detected logical drive window, press "Y" to enter the next step. As shown below
7. After adding the partition that needs to be restored, you can see the partition information directly on the right side of the interface. As shown below
8. After completing the above operation, press "Esc" to exit the tool. A red prompt box will pop up. Press "Y" to confirm the save. A warning box will pop up. Press "Y" again to confirm, and then press any key. Continue, and finally press any key to exit the tool and restart the computer. As shown below
The above is the method shared by the editor for partition recovery using the MaxDOS toolbox. Friends who don’t know how to do it should hurry up and learn it.
