Some novice friends still don’t understand the operation of using CAM350 to measure PCB boards. Below, the editor will share the operation process of using CAM350 to measure PCB boards. I hope friends in need can come and learn together.
After opening the PCB board file to be processed, click Settings—Unit and click OK
Select the metric system in the pop-up window, then select the smallest unit, here it is 1/10000, and click OK.
Click the minimum operating distance in the upper left corner and change it to minimum, at least 0.001:0.001;
If the pcb picture is reflected at this time, click Edit-Mirror in sequence.
At this time, hold down A on the keyboard and left-click the pcb diagram to complete the correction.
Click Info—Measure, and the windows that pop up on the right are point-to-point measurement; line measurement; network measurement, as shown in the figure
Click the measurement method according to the type of measurement required. As shown in the figure, select line measurement, click on the two pads that need to be measured, and the distance information between the two pads will be displayed in the upper left corner, as shown in the figure.
The above has shared with you the operation content of using CAM350 to measure PCB boards. Friends in need should hurry up and read this article.
