Want to get more familiar with the Friendly Serial Port Debugging Assistant software? Today, the editor will share how to use the Friendly Serial Port Debugging Assistant. If you are in need, hurry up and take a look. I believe you will not be disappointed.
1. After downloading and installing the Friendly Serial Port Debugging Assistant, find the icon on the desktop and double-click to run it. The main interface is as follows:
2. Select the baud rate according to the information sent from the serial port. The baud rate is selected according to actual needs. Make sure that the sending and receiving are consistent, otherwise the data may not be received. Sometimes it can be received, but it is all garbled.
3. According to the transmission protocol, set the data bit, check bit, and stop bit. These three also need to be consistent with the sending end. Generally speaking, the default setting is 8-N-1.
4. After connecting the hardware, select the transmission port corresponding to the USB port on the computer.
5. Set the data sending and receiving mode and select according to actual needs.
6. Click "Run" to send and receive data packets
7. The serial port debugging assistant can also debug TCP/UDP data packets. As shown in the figure below, its usage is similar to the former.
Dear friends, after reading the above exciting content, you all know how to use the Friendly Serial Port Debugging Assistant!
