Don’t know how to use Multisim14.0 for basic circuit simulation? In fact, the operation is very simple. Here the author will share the operation method of using Multisim14.0 for basic circuit simulation. Friends in need should not miss it.
Open the Multisim14.0 software,
Place the capacitors, resistors, and other components we need,
After selecting, the window as shown in the picture will pop up. Select the specific model of the required device type.
Place a resistor component here and select the meter we need,
After drawing, we found that there is no power supply. How should the circuit run? We need to place the power supply and select the option pointed by the arrow in the picture.
After placement, our basic circuit loop is completed.
Found the simulation that was promised, click the run option pointed by the arrow in the picture, as shown in the picture. This completes the circuit diagram.
The above explains how to use Multisim14.0 for basic circuit simulation. I hope friends in need can learn it.
