Recently, some users have encountered the problem that proe drawings have no view direction. Below, the editor will share the solution skills for proe drawings that have no view direction. I hope it will be helpful to you.
Open a drawing.
Expand the view list and you will find that there are no normal six view directions. What should you do?
Method one:
Assemble the component form of the drawing to the newly created assembly drawing.
Method two:
Create a new view direction. The steps are as follows, click on the icon in the picture.
Select the front and upper plane (if these two faces are difficult to select, you can also change the face to select another direction).
Expand Save, enter a name, Save-OK.
Expand the view list again, and there will be a new front direction. You can create other directions in the same way.
Dear friends, after reading the above wonderful content, you all know that there is no solution to the view direction of proe drawings!
