When using Wireshark, some newbies will encounter some problems, such as not knowing how to capture packets. The following editor will explain how to use Wireshark to capture packets. I hope it can help you.
First open the Wireshark software.
Click the capture network interface card selection button and select the network card interface that needs to be captured; if you are not sure which network interface it is, you can see the interface with the most changes in the packets item data, select it and click "start" to start capturing packets.
If special configuration is required, you need to configure the packet capture money first. Click the configuration operation button on the way to enter the packet capture configuration operation interface and perform the corresponding configuration; after the configuration is completed, click "start" to start packet capture.
After starting to capture packets, you can see that the data packets passing through the network interface have been captured. If you want to only see the data packets you care about, you can enter the filtering conditions in the "Filter" column; the filtering conditions are: There are many, you can search for "wireshark package filter conditions" on Baidu to find them.
If the desired data packet is not captured, you can click the re-capture button; or after capturing the data packet you need, you can click the red stop button.
The above is the operation method of wireshark packet capture brought to you by the editor. Let’s learn together. I believe it can help some new users.
