It is estimated that friends who are buying Multisim14.0 for the first time may not be able to draw operational amplifier circuits. Today, the article brought by the editor focuses on sharing the graphic tutorial of drawing operational amplifier circuits in Multisim14.0. Let’s take a look.
First open the Multisim14.0 software and select the "Menu Bar" -> "Tools" option.
Select the "Circuit Wizard"->"Op Amp Wizard" option,
Set the amplification parameters you need,
After completion, click "Verify" -> "Build Circuit".
After completion, just place it on the picture, as shown in the picture;
You can test it with a multimeter in the simulation software to determine whether the circuit is correct.
For those of you who have just come into contact with the Multisim14.0 software, after studying this graphic tutorial on drawing an operational amplifier circuit using Multisim14.0, do you think it will be easier to operate it in the future?
