What should I do if the wifi sharing wizard fails to start and displays 1401? The wifi sharing wizard is a wireless wifi sharing software. As long as there is a wifi network in the area, you can share data with others through the wireless network. However, recently some users have reported that the wifi sharing wizard failed to open DHCP. What does this mean? How should we solve it? The following editor will introduce to users the solution to the problem of 1401 when the wifi sharing wizard fails to open.
Solution to the problem that the wifi sharing wizard fails to start and displays 1401:
1. Open the CMD command prompt and use the netsh command to manually open the bearer network;
netsh wlan set host mode=allow (Enter)
netsh wlan start host (Enter), as shown in Figure 1:
(Figure 1)
2. Then run the command command netstat -a -p udp -o (Enter) to check the program occupying the port, and find the program occupying port 67 of 192.168.23.1 (24.1~33.1). Remember its PID, as shown in the figure 2 shown:
(Figure 2)
3. Finally, end the process corresponding to the PID in the task manager, and then open the sharing wizard, as shown in Figure 3:
(Figure 3)
4. If you cannot see the PID in your process, you can see it according to the following method, as shown in Figure 4:
(Figure 4)
The above is the solution that the editor introduced to users when the wifi sharing wizard fails to open and 1401 appears. I hope it can help everyone!
The editor recommends:
What is the reason why the webpage cannot be opened using wifi sharing wizard?
What is the reason why the wifi sharing wizard fails to open and error 1502 appears?
How can the wifi sharing wizard blacklist others?
