Many music itself is very light volume. If you want to increase its volume, you can directly handle this music. Today, I will share the specific operation steps for GOLDWAVE to adjust the original volume of music. I hope it can help everyone.

Open the software and drag the audio file into the software. You can also click [File] – [Open] in the menu bar above to add an audio file that needs to be edited.

Click on the menu bar and select [Change Volume] in [Volume] in the [Effect] toolbar. In the pop-up dialog box, you can modify the original audio volume. Press "+" or "-" to increase or decrease the volume respectively. or the percentage of reduction can also be in "+" As you can see on the lower right side of "+", you can also directly enter the increase or decrease percentage to the right of "+". After adjusting, press "OK". If you observe carefully, you will find that if you increase the adjustment, the audio order spectrum will It becomes higher, and vice versa, it shrinks. Of course, the larger the adjustment range, the more obvious it will be:

Then select "Save As" in "File" to resave it as a new audio file. If you want to overwrite the original file, just select "Save". At this time, you can compare it with the original audio file to see if the volume has changed. increased or decreased.

The above article explains the specific operation steps of GoldWave to adjust the original volume of music. I hope friends in need can learn it.