Recently, some friends have asked the editor how to set the file upload protocol in Xshell. The following will bring you the method of setting the file upload protocol in Xshell. Friends in need can come and learn more.

Step 1: First click the Open button in the file menu on the left side of xhell, as shown in the figure:

Step 2: In the opened session page, click the Properties button, as shown in the figure:

Step 3: In the properties interface, click File Transfer on the left, as shown in the figure:

Step 4: In the upload protocol location, set it as needed, as shown in the figure:

Step 5: After setting up, click OK below, as shown in the figure:

The above is the entire content of how to set the file upload protocol in Xshell brought to you by the editor. I hope it can help you.