How to draw an arrow in AutoCAD 2007? In fact, it is very simple. The following is the method of painting arrows compiled by Xiaobian. Friends who need it to learn together!

First, open the AutoCAD 2007 software, as shown below, set as orthogonal.

Then enter "PL" in the command bar.

Then, as shown in the figure below, formulate a starting point.

Subsequently, enter the "W" command and click Enter.

After that, enter the number "30" in the command bar below.

Then, slide the mouse to the specified next point.

Then, enter "100" in the command bar, as shown in the figure below, click the Enter key.

Finally, the arrow drawn is as follows.

Above explained AutoCAD 2007 drawing arrow methods. I hope friends who need it to learn.