Many friends are not familiar with the Adobe Illustrator CS6 software, and they do not know how to connect line segment breakpoints when they start using it. Below, I will share a graphic tutorial on connecting line segment breakpoints in Adobe Illustrator CS6. I hope it will be helpful to you.

Operation method one:

​​Select the "Direct Selection Tool" in the toolbox, which is the white arrow, and only select the two ends that need to be connected.

Press the shortcut key Ctrl+G, and the two lines are about to connect, or the object in the menu bar -marshalling.

Operation method two:

​​Select the "Direct Selection Tool" in the toolbox, which is the white arrow, select a node and move it to another node.

Note that it is not over yet. At this time, the two lines seem to be one line, but they are actually two lines. If you move it with the selection tool, you will find that it is two lines, but they are next to each other. At this time, select the "Direct Selection Tool" to select these two endpoints, and then press the shortcut key Ctrl+J to group them to merge them into a line.

Friends who still don’t know how to connect line segment breakpoints in Adobe Illustrator CS6, don’t miss this article brought by the editor.