I believe that everyone will mark some dimensions when using AutoCAD2010, so how to mark linear dimensions? Here I would like to share with you the tutorial on how to mark linear dimensions in AutoCAD 2010. I hope it will be helpful to you.

First open AutoCAD2010 and enter the interface as shown in the figure.

This article uses this straight line for demonstration.

Click on the annotation, and the mark will be where the arrow points.

​ ​Then click the origin first.

Click on the end point of the straight line.

​ ​Then you need to specify the position. You can adjust it by moving the mouse up and down. After adjusting, just click once.

The result is shown in the figure.

Come and learn the operation content of linear dimension marking in AutoCAD2010 in this article today. I believe you will be comfortable in future use.