3DMAX is a good software, and the construction model is very convenient. So in the process of editing the 3DMAX model, if you want to use the capture command, how should you operate? Next, I will explain the 3DMAX model to use the graphic operation content of the capture command. I believe it can help you.

1. Open 3DMAX and take the rectangle as an example to draw a model.

2. Right -click the long press of the capture switch, and there will be 3 options, one is 2 -dimensional capture, that is, the capture on the grid plane. One is 2.5 -dimensional capture, which is used to capture the graphic capture of 3 dimensional space, and the other is a 3 -dimensional capture to capture 3 -dimensional space.

3. Perform some settings, open the grid and capture settings, and select the endpoint on the capture tab. Then turn off.

4. For the convenience of understanding, press F3 to enter the wire frame mode, and the cubic body becomes such a graphic. Show in a wire frame.

5. If you want to draw a long square next to a rectangular point, for example, if you want to want to click on a blank space on the top view, select the corresponding view, we can put the mouse on one of the endpoints and appear as appear as appear. When capturing the icon, the left button is dragged to create.

6. After painting, you must develop the habit of closing and capture to prevent the wrong painting.

Here are the graphic tutorials that capture commands with the 3DMAX model. Friends who need it, please take a look at this article.